OpenVPN config server-side up & running:
[root@icissmb ~]# config show openvpn-bridge
openvpn-bridge=service
ConfigRequired=disabled
CrlUrl=http://localhost:940/phpki/index.php?stage=dl_crl_pem
UDPPort=1194
access=public
clientToClient=enabled
endPool=192.168.0.195
management=localhost:11194:fymKoRFjWlNt5rRcFXOzdFyLA
maxClients=20
redirectGW=always
startPool=192.168.0.155
status=enabled
tapIf=tap0
userAuth=CrtOnly
OpenVPN client .ovpn file:
rport 1194
proto udp
dev tap
nobind
# Uncomment the following line if your system
# support passtos (not supported on Windows)
# passtos
remote sogo.icis.it
tls-client
remote-cert-tls server
# Replace user.p12 with the certificate
# bundle in PKCS12 format
pkcs12 info-open-vpn-bridge.p12
# You can replace the pkcs12
# directive with the old ones
#ca cacert.pem
#cert user.pem
#key user-key.pem
mtu-test
comp-lzo
pull
Server hosting OpenVPN bridge runs on 192.168.0.0, single network card, server-only mode, behind a router natting port 1194 udp to server (192.168.0.127), DG for the server is 192.168.0.240 (the router), DNS server info left empty.
The client I'm connecting from runs on 192.168.35.0
I can connect with OpenVPN client form Windows client, I get 192.168.0.155 IP, then from a dos task I can ping 192.168.0.127 but any other adress on 192.168.0.0 is unreachable.
I suppose something faulty in routing but I can't find what.
The same config (appearently the same) is working fine in four other servers.
10 Replies
1449 Views