Hello,
Today i tried to install this type of card on a 2nd Server, Asterisk 1.4.19 and sail-2.2.1-617 is running.
lspci -v
07:02.0 Ethernet controller: Digium, Inc.: Unknown device 8005 (rev 11)
Subsystem: Digium, Inc.: Unknown device 8005
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B+
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (16000ns min, 32000ns max), Cache Line Size 10
Interrupt: pin A routed to IRQ 201
Region 0: I/O ports at 1000 [size=256]
Region 1: Memory at 92200000 (32-bit, non-prefetchable) [size=1K]
Expansion ROM at fffe0000 [disabled] [size=128K]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=100mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
lspci -vn
07:02.0 Class 0200: d161:8005 (rev 11)
Subsystem: d161:8005
Flags: bus master, fast Back2Back, medium devsel, latency 32, IRQ 201
I/O ports at 1000 [size=256]
Memory at 92200000 (32-bit, non-prefetchable) [size=1K]
Expansion ROM at fffe0000 [disabled] [size=128K]
Capabilities: [c0] Power Management version 2
When i probe the card i get:
Found following card...
07:02.0 Ethernet controller: Digium, Inc.: Unknown device 8005 (rev 11)
Subsystem: Digium, Inc.: Unknown device 8005
Flags: bus master, fast Back2Back, medium devsel, latency 32, IRQ 201
I/O ports at 1000 [size=256]
Memory at 92200000 (32-bit, non-prefetchable) [size=1K]
Expansion ROM at fffe0000 [disabled] [size=128K]
Capabilities: [c0] Power Management version 2
Requesting Load of wctdm24xxp ...
Loaded wctdm24xxp...
No Telephony Boards found on second pass ...
Signalling asterisk daemon to load ZTDUMMY for timing purposes
How can i solve this ?
regards
fpausp