i have follow the guida and edit with hexeditor the module..
now the ethernet is recognized!!! the led on switch gigabit is power on at gigabit, BUT my client send files at 12000KB/s !!!
why?
dmesg |grep eth
divert: not allocating divert_blk for non-ethernet device lo
divert: allocating divert_blk for eth0
eth0: VIA Rhine II at 0xe8001000, 00:40:63:c3:8c:17, IRQ 11.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
divert: allocating divert_blk for eth1
eth1: Identified chip type is 'RTL8169s/8110s'.
eth1: RTL8169 at 0xde85e000, 00:15:e9:f0:18:0f, IRQ 10
divert: freeing divert_blk for eth1
divert: freeing divert_blk for eth0
divert: allocating divert_blk for eth0
eth0: Identified chip type is 'RTL8169s/8110s'.
eth0: RTL8169 at 0xde8e6000, 00:15:e9:f0:18:0f, IRQ 10
r8169: eth0: link up
divert: allocating divert_blk for eth1
eth1: VIA Rhine II at 0xe8001000, 00:40:63:c3:8c:17, IRQ 11.
eth1: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
[b]eth1: link up, 100Mbps, full-duplex, lpa 0x45E1[/b]
*bpivk* sorry, i dont understand..