Hi Landry,
Finally been able to get this info for you....
[root@mserver ~]# sensors
w83627thf-isa-0290
Adapter: ISA adapter
VCore: +1.47 V (min = +0.70 V, max = +1.87 V)
+12V: +11.73 V (min = +0.12 V, max = +5.05 V)
+3.3V: +3.36 V (min = +0.22 V, max = +2.03 V)
+5V: +5.04 V (min = +3.20 V, max = +6.67 V)
-12V: -14.91 V (min = -14.91 V, max = -14.91 V)
V5SB: +4.95 V (min = +1.37 V, max = +1.94 V)
VBat: +3.50 V (min = +2.56 V, max = +0.29 V)
fan1: 0 RPM (min = 17763 RPM, div = 2)
CPU Fan: 3026 RPM (min = 675000 RPM, div = 2)
fan3: 0 RPM (min = 10384 RPM, div = 2)
M/B Temp: +35°C (high = -101°C, hyst = +1°C) sensor = thermistor
CPU Temp: +29.0°C (high = +70°C, hyst = +65°C) sensor = thermistor
temp3: +65.0°C (high = +70°C, hyst = +65°C) sensor = thermistor
ERROR: Can't get VID data!
alarms: Chassis intrusion detection ALARM
beep_enable:
Sound alarm disabled
eeprom-i2c-0-50
Adapter: SMBus Via Pro adapter at 5000
Memory type: DDR SDRAM DIMM
Memory size (MB): 512
i have tried ALL of the keywords above (eg fan1, CPU FAN, fan3, M/B Temp, CPU & temp3) in the sme7admin config without any luck.
I have checked the sme7admin.conf file and they are listed there as one would expect. Since getting the modules to load on startup I now have two system temps on my temp graph plus the two hdd temps i had before, but no matter what i enter into the config section, the temps are the same sensors each time and i cannot get ANY fan speeds at all.
any ideas?
All the rest of sme7admin works a treat, just not this bit..arrggghhhh!