I have upgraded an SME 6.0 server to 7.0 (pre1). The main HDD are SCSI on an Adeptec DTP raid controller. I have two additional IDE drives mirrored using an Adaptec 1200 IDE raid controller. This was removed for the upgrade as it has caused problems in the past. I am now trying to remount the file system on this drive. I am getting no success.
Fdisk reports the drive as being present (hde 60GB)
[root@linuxserver etc]# fdisk -l
Disk /dev/hde: 61.4 GB, 61492838400 bytes
16 heads, 63 sectors/track, 119150 cylinders
Units = cylinders of 1008 * 512 = 516096 bytes
Device Boot Start End Blocks Id System
/dev/hde1 1 119150 60051568+ 83 Linux
Disk /dev/hdg: 61.4 GB, 61492838400 bytes
16 heads, 63 sectors/track, 119150 cylinders
Units = cylinders of 1008 * 512 = 516096 bytes
Disk /dev/hdg doesn't contain a valid partition table
Disk /dev/i2o/hda: 12.8 GB, 12869173248 bytes
255 heads, 63 sectors/track, 1564 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/i2o/hda1 * 1 13 104391 83 Linux
/dev/i2o/hda2 14 46 265072+ 82 Linux swap
/dev/i2o/hda3 47 1564 12193335 83 Linux
[root@linuxserver etc]#
Trying to mount it produces the following error
[root@linuxserver etc]# mount -a
mount: /dev/hde1 already mounted or /home/e-smith/files/ibays busy
[root@linuxserver etc]# fdisk -l
Snip from fstab
/dev/hde1 /home/e-smith/files/ibays ext3 usrquota,grpquota 1 2
Now I tried creating a new temp mount point but got the same error when tryinf to mount the device.
Where should I look from here I feel I must be missing something basic ?
Cheers
Mike Drummond