ldkeen,
[root@ice root]# ping 192.168.10.1
PING 192.168.10.1 (192.168.10.1) from 203.213.xxx.xxx : 56(84) bytes of data.
64 bytes from 192.168.10.1: icmp_seq=1 ttl=64 time=44.4 ms
64 bytes from 192.168.10.1: icmp_seq=2 ttl=64 time=45.7 ms
64 bytes from 192.168.10.1: icmp_seq=3 ttl=64 time=47.2 ms
--- 192.168.10.1 ping statistics ---
3 packets transmitted, 3 received, 0% loss, time 2021ms
rtt min/avg/max/mdev = 44.419/45.796/47.234/1.163 ms
[root@ice root]# ping 192.168.10.67
PING 192.168.10.67 (192.168.10.67) from 203.213.xxx.xxx : 56(84) bytes of data.
64 bytes from 192.168.10.67: icmp_seq=1 ttl=127 time=46.0 ms
64 bytes from 192.168.10.67: icmp_seq=2 ttl=127 time=82.3 ms
64 bytes from 192.168.10.67: icmp_seq=3 ttl=127 time=113 ms
--- 192.168.10.67 ping statistics ---
3 packets transmitted, 3 received, 0% loss, time 2017ms
rtt min/avg/max/mdev = 46.021/80.482/113.098/27.417 ms
I'm trying to implement a tunnel between two SME6 without success:
200.200.230.2XX
200.200.230.1XX
Two things are happening:
1- If I add the remote network to the local network, it tries to go out using the IP of the local gateway. If I remove, then it goes out as you put above.
2- # ipsec eroute
0 192.168.130.0/24 -> 192.168.0.0/24 => %trap
0 192.168.130.0/24 -> 200.200.230.1XX/32 => %trap
0 200.200.230.2XX/32 -> 192.168.0.0/24 => tun0x5164@200.200.230.1XX
0 200.200.230.2XX/32 -> 200.200.230.1XX/32 => tun0x3f88@200.200.230.1XX
ifconfig does show traffic on the ipsec0 interface in both sides.
Any ideas on what could I be doing wrong?
Regards,