Topic: Public DNS on SME 6.01

[edb]

I would still like to get the install/uninstall script. Thanks

[smeghead]

Hi edb

Copy on its way, enjoy!

[edb]

Thank you ...

[Jon_Reynolds]

I'll test the scripts also if you wouldn't mind sendimg them my way.

jonr@destar.net in case I don't have it in my profile.

[smeghead]

Hi Jon

Sent, enjoy

[dexter]

script please!

andrej(at)pcklinika.com

Tx,

[GoVeGeTa]

Can someone make public the install/uninstall script please.

The only way to improve on it is to have it released for all to try on different systems setups, etc etc..............


So anyone gonna share it or what????????!!!!!!!!!

[smeghead]

Anyone care to post their success/failure using these scripts.

Feedback so far has been positive but I'd like an update from those using them.

If there are no problems reported then I will post them for general consumption.

Any additional info on the performance of TinyDNS when run this way would also be welcome.

TIA

[GoVeGeTa]

hey smeghead,
cheers for the script, gonna try it out now!

Let you know results!

[GoVeGeTa]

My install failed,
not due to the script - but to the fact i had a different version of sme-server running (6.0 not 6.0.1 -)
So am almost finished downloading 6.0.1, will try it out and then post back here my results!

Other than that it all looks quite good (the script!?)

[smeghead]

Hmm, I guess 6.0 should work, can you remember if there were any errors posted when the script ran?

If using a router don't forget to forward port 53 to the SME box otherwise it will never work!

HTH

[GoVeGeTa]

yeah there were errors when installing it but i cant remeber them, i just tried installing on 6.0.1-01
and here is what it says


Copying working files to PUBLICDNS2157
Copy complete..............

This installation only supports SME 6.0 or higher..
exiting


and that is exactly what i get!

What could be the problem?????????????

I have port 53 tcp/udp forwarded to my sme box!

[smeghead]

.. the script is saying your using MSE 6.0 not 6.0.1, I have sent you a copy with this check removed to try out.

HTH

[GoVeGeTa]

i actually went through the script myself and removed the check, all it does is say
"
Copying Files...................
Completed"

or something along those lines.

Is that all it is meant to do?

[GoVeGeTa]

ok i uncommented all the commands you had commented out.

all ichanged was the check

if [ $IS_SME60 -ne 0 ]

to

if [ $IS_SME60 -ne 1 ]

so in essence the install continues if it fails that check.

After that all i get is

command not found
no such file or directory

errors.

If you let me know what version you have tested your script out on that might help out a bit.

When i look at the install script it looks ok to me,
so i cant see where it could be going wrong!