Topic: [ipsec setting]

[LeeChunSeong]

We are setting ipsec to communicate via VPN(ipsec) between two e-smith server&gateways.

We downloaded two rpms, read the how-to document. and then am setting.
But it does not work.

We tried to set so many combination of setting, but still does not work.

This is a network configuration to test about ipsec vpn connection.

client(192.168.100.10)---(191.168.100.1) e-smith-1 (200.100.100.10) ---------------(200.100.100.1) Gateway(router)--------------(200.100.100.20) e-smith-2(192.168.200.1) --------------(192.168.200.20) client

over above network configuration, we set like following on vpn setting field using e-smith-1 server&gateway manager.

remote route internal ip address : 192.168.200.1
remote route internal subnet mask : 255.255.255.0
remote router external server IP address : 200.100.100.20
remote router's default gateway ip address : 200.100.100.1
remote router's public encryping key : entered public key of e-smith-2 server.
remote network NAT'ed : yes
protect network to network traffic
protect gateway to gateway traffic
protect gateway to network traffic

for above 3 items, we tried to test using combination of each field settings.

local machine acts as : server (for e-smith-2, client or server)

we still did not succeed.

give me nice help

thanks

[Lloyd Keen]

Lee,
Do you have the IPsec interfaces up on both gateways? to check run /sbin/ifconfig as well eth0, eth1 and lo you should have some ipsec interfaces now? Also, the two lans have to be on different subnets, try setting one subnet up in the 10.10.x.x range.